diy projects

Bored With Dull-Look On Your Wood Furniture, Here 9 Tips On Make It Shine Again

Source: vermontwoodsstudios.com

During the DIY process, staining unfurnished furniture is one of the expensive steps. Therefore, when you about to decide that you will stain your furniture, you need to finish it perfectly because staining is permanent and hard to maintain if there is a miss-leading.

Most the expert recommends that the staining process can be done by these following products such as oil-based and water-based stains then including wood conditioners. After read all of those suggestions. I ensure that you will be confused.

Bored With Dull-Look On Your Wood Furniture, Here 9 Tips On Make It Shine Again

So, in this article, I would like to give you some further guidance on how to staining wood in the correct way. Therefore, before I give you the tips. I would like to suggest you prepare some supporting tools for this process.

There is an eye protector to protect your eye and safety glasses and rubber gloves to protect your skin. Because anything that leaves a stain a scratch the wood will be a stain on the fingers also.

Wear special clothes for work. Because some stain will stubborn if its place on the cloth. Then, it’s important to do a testing spot on the furniture before starting the entire process.

1. Apply The Wood Conditioner

Source: tr.pinterest.com

The first steps are to clean the surfaces, you can use a wood conditioner to make it done. Rib it there around 15 minutes to make it absorbs. Next, you can continue the steps by applying staining liquid on the table.

2. Staining Liquid Mixture

Source: thenovastudio.com

Then, the most common staining liquid is Oil-based stains. This liquid consists of the mixture dyes and pigments with mineral spirits. Ensure that you mix them clearly to bring the dyes and pigments up from the bottom. Then, we will get a full-color mixture. Make sure that you work in a well-ventilated area to avoid fumes on oil-based stains.

3. Staining Process

Source: reddoorfurnitureeco.blogspot.com

Apply the staining liquid with a brush before putting it on the surface. But, it based on the preference. You might use a staining brush, then work together with the grain then set it. Then, wipe the stain on the surface immediately to get a lighter tone. Further, if you want a deeper tone you might leave the liquid 10 minutes longer before wiping it up.

4. Wipe The Excess

The fourth step is to ensure that you wipe off the liquid excess from the staining process at the same point that the grain of the wood. It ensures that the stain will get into the wood, then just laying on the top.

5. Avoid Fumes

Source: ourhandcraftedlife.com

The fifth step is about evading the fumes. you can use a water-based stain. Further, these types of staining liquid also offer a wide variety of colors, especially oil-based colors. Steps to apply water-based stain similar to oil-based instruction. Then, if the stain needs to be darker, you might repeat the steps and apply more liquid.

6. Finishing Process

When you already complete your staining process, Due to the stain only provide a color then applies a finishing liquid on the top of the stained wood. Otherwise, when you have no time you might combine both of those products then finish it with one coat. Rib the liquid residue with a brush. Brush them carefully with these types of finish.

7. Further Steps

Source: bioprojectslb.com

When it’s possible you can mix stain to create a customized color from both stains and water-based liquid or oil-based liquid. Remember do not mix oil with water.

Remember to calculate the amount of each liquid so you can duplicate when it’s necessary.

8 . Additional Steps

You can apply water-based finishing on the oil-based stain. But, you need to wait along 24 hours until the mineral spirit is eliminated from the oil-based stain.

9. Keep Them Staining

The last, you need to keep them staining. Because stain can be expensive.
In short, understand to make a furniture staining will guide you to make it

You may also like

Comments are closed.

More in diy projects